Attention: Farmers & Mechanics!!!
Looking for

Ford Tractor Axle & Steering Parts?

You Can Benefit from:

Ford Tractor Wheel Hub

Ford Tractor Wheel Hub

  1. The Largest Online New Aftermarket Parts Store in the USA-95,000 part numbers and growing
  2. Seeing Pictures, Prices, Descriptions, and Availability before you buy
  3. Paying Up to 50% less that Dealer Prices
  4. The lowest freight rates from UPS, DHL, and other couriers.
  5. Call Easy Tractor Parts (1-877-668-7278) or Click the Image Below to Enter the

Ford Tractor Parts Catalog.

Tractor-Parts-Catalog

Ford Tractor Axle and Steering Parts

Ford tractor Axle parts and Ford Tractor steering parts are separated into nine (9) different sections in the tractor parts catalog.

These nine (9) sections are axle related parts, axle & knees, power steering pumps & motors, spindles, steering arms & shafts, steering parts, tie rods & ball joints, wheel bearings, sleeves, wheel hubs and caps.

The axle related parts section will include front wheel hubs and stud bolts, the spindle bearings and bushings, front pivot bushing, hub cap, front wheel nut, radius rod, seal, socket radius ball, socket radius cap, and taper cone bearings.

The knee section will include the front radius rod support bracket, and the front axle support.  One of the major components of the front axle section is the right and left hand side spindles. The Ford 5000 tractor has two sets of spindles for each side. One set of spindles was for 10 x 16 tires, and the other set for tires that are not this size.  The wheel bearing kits are similarity stocked; with two different types of bearings depending on if the tire size is 10 x 16 or not.

The Ford 5000 tractor has three different types of steering arms, one right side and one left side. There is one dual center steering arm for use with power steering tractors that were manufactured in 1970 to 1975.

Other Ford Tractor steering parts will include ball bearing, steering bushings, drag link, cylinder pin, steering shaft, steering wheel and nut, and cylinder repair kit for the power steering cylinder.

The tie rods are of various types and vary with the tractor type. Such differences such as whether the tractor is power steering or manual, or the year of manufacture. Drag link ends are sold separately from the drag kinks assemblies sometimes, as are the tie rod ends.

The front wheel hub for the Ford 5000 tractor are two different six (2) stud bolts  hubs, one for rims that uses 10 x 16 tires, and the other for normal tire sizes.

For power steering tractors, hydraulic lines are used as a part of the steering system. Hydraulic lines and fittings are available for these power steering cylinders and power steering pumps. Hose lengths can vary from sixteen (16) inches, twenty seven (27) inches, to thirty four (34) inches in lengths with various kinds of fittings.

The Ford 4000 tractor has two different steering wheels, one for manual steering and one for power steering.


    Ford Tractor Radiator parts

    A tractor cooling system will include a radiator, radiator fan, fan pulley, fan belt, water pump, lower radiator hose, upper radiator hose, clamps, thermostat, water temperature gauge, temperature sensors, and radiator cap, drain faucet, tank heater, engine block heater, gaskets and appropriate coolant.

    The ford 5000 tractor has the 134 CID gas engine, 175 CID Diesel engine, 192 CID Gas engine, 201 CID diesel engine, 201 CID gas engine, 233 CID diesel engine, the 256 CID diesel engine, or the 256 CID gas engine, 256 CID Turbo diesel engine, 268 CID non turbocharged engine, 268 CID turbo diesel, 401 CID Diesel engine or the 401 CID Turbo Diesel engine.

    All of these vary with the amount of horse power that the engine is capable of, and the type of fuel used.

    The Ford Tractor radiator for the 5000 is of two types. These are either with oil cooler or without oil cooler. The earlier models of the tractor were not manufactured with the oil cooler bolted onto the radiator, as were the models after 1965.

    The radiator cap can either be a 13 lb or a 7 lb cap pressure. This tractor typically carries a six (6) blade radiator fan.

    This Ford tractor radiator water pump can be one of two types-either a water pump with a single groove pulley, or for the tractors manufactured 1965 to 1975, the water pump uses a double groove pulley. The BSD442 engine uses a single pulley without a back housing.

    The thermostats can be of three different temperature ratings. Ford tractor radiator for the super Dexta is available for the years 1962 to 1964. For this tractor, there is a 7

    Ford Tractor Radiator parts

    A tractor cooling system will include a radiator, radiator fan, fan pulley, fan belt, water pump, lower radiator hose, upper radiator hose, clamps, thermostat, water temperature gauge, temperature sensors, and radiator cap, drain faucet, tank heater, engine block heater, gaskets and appropriate coolant.

    The ford 5000 tractor has the 134 CID gas engine, 175 CID Diesel engine, 192 CID Gas engine, 201 CID diesel engine, 201 CID gas engine, 233 CID diesel engine, the 256 CID diesel engine, or the 256 CID gas engine, 256 CID Turbo diesel engine, 268 CID non turbocharged engine, 268 CID turbo diesel, 401 CID Diesel engine or the 401 CID Turbo Diesel engine.

    All of these vary with the amount of horse power that the engine is capable of, and the type of fuel used.

    The Ford Tractor radiator for the 5000 is of two types. These are either with oil cooler or without oil cooler. The earlier models of the tractor were not manufactured with the oil cooler bolted onto the radiator, as were the models after 1965.

    The radiator cap can either be a 13 lb or a 7 lb cap pressure. This tractor typically carries a six (6) blade radiator fan.

    This Ford tractor radiator water pump can be one of two types-either a water pump with a single groove pulley, or for the tractors manufactured 1965 to 1975, the water pump uses a double groove pulley. The BSD442 engine uses a single pulley without a back housing.

    The thermostats can be of three different temperature ratings. Ford tractor radiator for the super Dexta is available for the years 1962 to 1964. For this tractor, there is a 7 lb radiator cap, lower radiator hose, and upper radiator hose. Between the years 1965 to 1975, the Super Dexta Ford tractor uses a water pump with double pulley. For the years 1955 to 1965, the engines use a water pump with a single pulley, regardless if the engine was a gas ror diesel engine.

    Some of the Super Dexta’s uses the BSD333 engine, and this water pump is a single pulley without a back housing.

    There are two ford tractor radiators for the Super Dexta, depending on if the engine is a three (3) cylinder engine or a four (4) cylinder engine.  The upper radiator hose and the lower radiator hose vary depending on the type of engine used.  The thermostat ranges from 168 degrees to 192 degrees.

    Fan belts are available for most models of Ford Tractors.

    lb radiator cap, lower radiator hose, and upper radiator hose. Between the years 1965 to 1975, the Super Dexta Ford tractor uses a water pump with double pulley. For the years 1955 to 1965, the engines use a water pump with a single pulley, regardless if the engine was a gas ror diesel engine.

    Some of the Super Dexta’s uses the BSD333 engine, and this water pump is a single pulley without a back housing.

    There are two ford tractor radiators for the Super Dexta, depending on if the engine is a three (3) cylinder engine or a four (4) cylinder engine.The upper radiator hose and the lower radiator hose vary depending on the type of engine used.The thermostat ranges from 168 degrees to 192 degrees.

    Fan belts are available for most models of Ford Tractors.